LTO7 Tape Drive Code Fixlist:

=====================================================================
Drive Code Level: LTO7_G9Q1  (LTO7_HH_SAS)

Fixes
=====================================================================

Fix several drive reset conditions
Correct data for several log pages including pages 16h, 17h, and 30h
Library/drive interface communication improvements
Media motion handling improvements
Error handling changes
Addition of Iterative decode error recovery procedure
Report correct status for cartridge conditions
Allow unthread tape after unload failure (2E0C)
Fix for load failure (2E12)        
Fix for read/write error (78B5)

=====================================================================
Drive Code Level: LTO7  (LTO7_HH_SAS)

LTO7_FA11
=====================================================================
Fixes

LN1: fix wrong handling of echo buffer                         
Request Sense did not return in progress sense        
Allow non-zero offsets for VPD read buffer                
Dispatch counter updates to task                               
Multi-initiator sense data collision                      
LN1-LDI: fix problem parsing some data out parameter lengths        
T10-OOB does not fail DPRP disabled encryption properly   
FCH: improve direct forced L-port negotiation                  
SendDiag (POST B) fails with SCD 'A' (FSC 52E5)           
FCH: Un-handled IRQ during host I/F re-enable via ADT mode page 
FCH: work around init cases where rx frames are not processed   
Unload hangs                                          
Improve echo buffer standards compliance                  
LN1-LDI: avoid sending data in data-in command payloads        
Tape stretch threshold and motor spec limit update        
Raise vibration detection threshold