3592 60S Tape Drive Code Fixlist:

===================================================================================================

Drive Code Level: 60S_713  (60S_FH_SAS)
Fixes:
===================================================================================================

Fix for incorrect queuing of commands which could cause LUN1 queue to hang
Fix the host interface LED updating
Fix certain failures during tape initialization that make the tape unusable (FSC CF11)
Fix and enhancement for repositioning errors 
Clear unthreaded status due to code download after load or unload
Fix unexpected reboot that sometimes occurs by reading mixed encrypted data near BOP
Fix unexpected endmarker found (FSC 6601)
Fix drive hang after rechuck failure due to head stuck during unload (FSC 78E3)
Improve MTR (Improve transition from deceleration to unspool in MTR)
Fix unload command hangs (no response) after unload failure with 2E0C (bottom sensor error)
Fix servo spacing error (FSC 5853)
Fix Locate/Space failure during HRTD recovery
Fix case where fibre channel wrap test can falsely fail (FSC A1C0)
Fix Read error case (FSC 7274)
Allow to load a tape whose validity is rfx=300 (FSC 8C3E)
Adjust calibration criteria in special cases
Improve calibration in certain conditions
Prevent tape run-off due to command queuing issue (FSC 2E12)
Remove LP3 passes from media EOL criteria
Fix FC resources error in PLOGI
Fix Read failure at EOW (FSC 5175)
Fix read SAW (Suspended Append Write) DS on BOW (FSC 6353)
Refresh tape pack after MTR
Fix Read recovery after CDSC error on ABF wrap
Fix Read failure on BOW (FSC 6353)
Fix Write failure when writing from BOT on brand new tape in append-only mode (FSC 6017)
Fix append failure
FIX tension shutdown due to inboard/outboard velocity mismatch (FSC 2E13)
Prevent drives with degraded tracks from writing. Drive will post FSC B3B1/D058 or 53B1/1058 and will be fenced until replaced
Fix drive panic due to too many incoming FC frames
Add support for service action 1Eh for Report/Set Automation Device Attributes commands
Fix UDS logical object validation broken by previous change
Fix write failure (FSC 2C30) on uninitialized WORM tape 20 minutes after loading cartridge
Fix for Read command timeout
Fix reel motor stall at direction change (FSC 58D1)



===================================================================================================

Drive Code Level: 60S_69E  (60S_FH_SAS)
Fixes:
===================================================================================================

Fix for incorrect queuing of commands which could cause LUN1 queue to hang
Fix Locate/Space failure during HRTD recovery
Fix UDS logical object validation broken by RAO on LTO support change
Improve and fix specific servo filter (fix skew issue)




===================================================================================================

Drive Code Level: 60S_69D  (60S_FH_SAS)
Fixes:
===================================================================================================

Log page parameter corrections
Error recovery enhancements
Error reporting corrections and improvements
Servo positioning and motion control improvements
Correctly set tape alert 32 and assign a different error code for Read CRC errors